Gladhand

Free sample

CDL permit practice test

Last updated · Published by Certloom Learning

How this page was made: Questions come from Gladhand's bank, drafted with AI from public CDL manuals and FMCSA rules and checked by a separate AI review against those sources (no licensed CDL instructor reviewed them). Written and published by Certloom Learning.

This free sample has 15 CDL knowledge test questions in English: 6 general knowledge, 3 air brakes, 3 combination vehicles and 3 road signs, each with an explanation in English and Spanish. The real knowledge tests need at least 80 percent on each test (49 CFR 383.135 (checked 2026-11-11)).

Which questions are in this practice test?

The same questions, listed here so you can read them without the interactive quiz. Open each one for the answer, the explanation and the manual section it comes from.

  1. What is the most important reason to inspect your vehicle?

    1. To keep the truck looking clean
    2. Safety for you and other road users
    3. To use time while you wait for a load
    4. To lower your fuel costs
    Show answer

    Answer: B. Safety is the most important reason to inspect. An inspection finds problems that could cause a crash or a breakdown before you drive.

    La seguridad es la razón más importante para inspeccionar. La inspección encuentra problemas que pueden causar un choque o una descompostura antes de manejar.

    California Commercial Driver Handbook §2.1 · gk01-001

  2. What is the minimum tread depth for the front tires?

    1. 8/32 inch in every major groove
    2. 2/32 inch in every major groove
    3. 1/32 inch in every major groove
    4. 4/32 inch in every major groove
    Show answer

    Answer: D. Front tires need at least 4/32 inch of tread in every major groove. Other tires need at least 2/32 inch, so 2/32 is not enough for the front.

    Las llantas delanteras necesitan por lo menos 4/32 de pulgada de dibujo en cada ranura principal. Las demás llantas necesitan 2/32, así que 2/32 no es suficiente adelante.

    California Commercial Driver Handbook §2.1 · gk01-011

  3. Why is a damaged rim a problem?

    1. It only changes how the wheel looks, not how it works
    2. It can cause the tire to lose pressure or come off
    3. It makes the engine work harder and run hotter on hills
    4. It causes the headlights to dim
    Show answer

    Answer: B. A damaged rim can let the tire lose air pressure or even come off the wheel.

    Un rin dañado puede hacer que la llanta pierda presión de aire o incluso que se salga de la rueda.

    California Commercial Driver Handbook §2.1 · gk01-021

  4. Which of these is an exhaust system defect?

    1. A vertical stack that is secure and not leaking any fumes
    2. Mounting brackets, clamps, and bolts that are all in place
    3. A muffler held by tight clamps
    4. Exhaust parts rubbing against fuel system parts or tires
    Show answer

    Answer: D. Exhaust parts must not rub against fuel system parts, tires, or other moving parts. Loose, broken, or missing pipes, mufflers, or brackets are also defects.

    Las partes del escape no deben rozar con partes del sistema de combustible, llantas u otras partes que se mueven. Los tubos, mofles o soportes flojos, rotos o que faltan también son defectos.

    California Commercial Driver Handbook §2.1 · gk01-031

  5. In step 3, before you start the engine, where should you put a manual gearshift?

    1. In reverse
    2. In neutral
    3. In the highest gear
    4. In first gear
    Show answer

    Answer: B. Make sure the parking brake is on and put the gearshift in neutral (or in park if the transmission is automatic) before you start the engine.

    Asegúrese de que el freno de estacionamiento esté puesto y ponga la palanca en neutral (o en park si la transmisión es automática) antes de encender el motor.

    California Commercial Driver Handbook §11 · gk01-041

  6. When you inspect the coupling, the fifth wheel locking jaws should be closed around:

    1. the head of the kingpin
    2. the landing gear
    3. the trailer apron
    4. the shank of the kingpin
    Show answer

    Answer: D. The locking jaws must be closed around the shank of the kingpin, not the head. If they close on the head, the trailer can come loose.

    Las mordazas deben cerrarse alrededor del cuello del perno rey (kingpin), no de la cabeza. Si cierran sobre la cabeza, el tráiler se puede soltar.

    California Commercial Driver Handbook §6.4 · gk01-051

  7. An air brake system is really three braking systems combined. Which three?

    1. Service brake, engine brake, and trailer hand brake
    2. Service brake, parking brake, and emergency brake
    3. Parking brake, retarder, and exhaust brake
    4. Emergency brake, ABS, and transmission brake
    Show answer

    Answer: B. Air brakes combine the service brake, the parking brake, and the emergency brake. Engine retarders and ABS help with braking, but they are not these three systems.

    Los frenos de aire combinan el freno de servicio, el freno de estacionamiento y el freno de emergencia. Los retardadores de motor y el ABS ayudan a frenar, pero no son estos tres sistemas.

    Texas CDL Manual (DPS DL-7C) §5.1 · air01-001

  8. Why is water in the air tanks dangerous?

    1. It makes the safety valve open at 100 psi
    2. It turns on the ABS malfunction lamp
    3. It makes the governor cut out at a lower pressure
    4. It can freeze in cold weather and cause brake failure
    Show answer

    Answer: D. Water can freeze in cold weather, and ice in the system can cause the brakes to fail. That is why you drain the tanks.

    El agua se puede congelar con el frío, y el hielo en el sistema puede hacer que fallen los frenos. Por eso se drenan los tanques.

    Texas CDL Manual (DPS DL-7C) §5.1.4 · air01-011

  9. What happens when you push the brake pedal (foot valve) down harder?

    1. The governor makes the compressor cut out
    2. More air pressure is applied to the brakes
    3. The same pressure is applied, only faster
    4. Air is let out of the spring brakes
    Show answer

    Answer: B. The harder you push the brake pedal, the more air pressure goes to the brakes. Letting up on the pedal reduces the pressure and releases the brakes.

    Entre más fuerte pise el pedal, más presión de aire llega a los frenos. Al soltar el pedal baja la presión y se sueltan los frenos.

    Texas CDL Manual (DPS DL-7C) §5.1.7 · air01-021

  10. Compared with an empty rig, how much more likely is a fully loaded rig to roll over in a crash?

    1. About 5 times more likely
    2. About 20 times more likely
    3. About 2 times more likely
    4. About 10 times more likely
    Show answer

    Answer: D. The manual says fully loaded rigs are 10 times more likely to roll over in a crash than empty rigs. The load raises the center of gravity, so the truck tips more easily.

    El manual dice que los equipos totalmente cargados tienen 10 veces más probabilidad de volcarse en un choque que los vacíos. La carga sube el centro de gravedad y el camión se voltea más fácil.

    Texas CDL Manual (DPS DL-7C) §6.1.1 · combo01-001

  11. When pulling trailers, when should you slow down to a safe speed for a turn?

    1. As you come out of the turn
    2. Before you go into the turn
    3. Only if the trailer starts to lean
    4. In the middle of the turn
    Show answer

    Answer: B. Slow down to a safe speed before going into a turn. Braking in the middle of the turn shifts weight and can cause a skid or rollover.

    Baje a una velocidad segura antes de entrar a la curva. Frenar en medio de la curva mueve el peso y puede causar un derrape o una volcadura.

    Texas CDL Manual (DPS DL-7C) §6.1.2 · combo01-011

  12. When should you check your mirrors to make sure the trailer is not skidding?

    1. Only when you are backing up
    2. Only once every few minutes
    3. Only when you enter a curve
    4. Any time you apply the brakes hard
    Show answer

    Answer: D. Check your mirrors any time you apply the brakes hard, so you can see a trailer skid as soon as it starts. Seeing it early gives you time to release the brakes.

    Revise sus espejos cada vez que frene fuerte, para ver un derrape del tráiler en cuanto empiece. Verlo temprano le da tiempo de soltar los frenos.

    Texas CDL Manual (DPS DL-7C) §6.1.5 · combo01-021

  13. SPEED LIMIT65TRUCKS55

    Cars around your truck are driving 65 mph on this road. What should you do?

    1. Drive 65 mph only in the left lane
    2. Drive 60 mph as a middle speed
    3. Match the speed of cars to stay with traffic
    4. Stay at 55 mph or less, even if cars go faster
    Show answer

    Answer: D. The truck limit applies to you no matter how fast cars are going. Keep your truck at or below 55 mph.

    El límite para camiones aplica para usted sin importar qué tan rápido vayan los carros. Mantenga su camión a 55 mph o menos.

    MUTCD 11th ed., Part 2B, SPEED LIMIT sign (R2-1) with TRUCKS plaque (R2-2P) · sign01-031

  14. NO PASSINGZONE

    A truck driver sees this sign on a two-lane road. What does it mean?

    1. Only trucks are not allowed to pass here, but cars may pass
    2. You are starting a section where you must not pass
    3. Passing is allowed again from here because the zone has ended
    4. Slow vehicles must pull over to let you pass
    Show answer

    Answer: B. This pennant-shaped sign marks the start of a no-passing zone. Do not begin to pass until the zone ends.

    Esta señal en forma de banderín (pennant) marca el comienzo de una zona donde no se puede rebasar. No empiece a rebasar hasta que termine la zona.

    MUTCD 11th ed., Part 2C, NO PASSING ZONE sign (W14-3) · sign01-041

  15. TRUCKSENTERINGHIGHWAY

    This sign is a yellow diamond with black letters. What does that shape and color tell you?

    1. It is a guide sign that gives directions to a place
    2. It marks a school zone
    3. It is a rule you must obey, with a fine if you break it
    4. It is a warning sign about a possible hazard ahead
    Show answer

    Answer: D. Yellow diamond signs are warning signs. They tell you about possible hazards or changes ahead so you can get ready.

    Las señales amarillas en forma de rombo (diamond) son de advertencia. Le avisan de posibles peligros o cambios adelante para que se prepare.

    MUTCD 11th ed., Part 2A (sign colors and shapes); Part 2C warning signs · sign01-051

How is this different from the real CDL knowledge test?

These are original practice questions, not the questions your state uses; states do not publish their test questions. Rules can also differ by state, so study your own state CDL manual too.

This free sampleGladhand full unlockYour state knowledge tests
Questions15880 permit questions plus 119 sign drillsSet by your state from an FMCSA-approved question pool (49 CFR 383.133(b)(1) (checked 2026-11-11))
LanguageEnglish, with Spanish help you can turn offEnglish, or another language only where your state offers one (383.133(b)(3) (checked 2026-11-11))
Passing scorePractice only, no pass markAt least 80% on each test (49 CFR 383.135 (checked 2026-11-11))

Next: how the CDL permit test works, step by step, the air brakes test and the combination vehicles test.

Get it on Google Play